Pro-Built Tools PB1200 Series Manual de Instalação descarregar pdf (Página 25)

GTO 4000XL Instruction Manual © 091610 15

RED wire to POSITIVE (+) terminal

BLACK wire to NEGATIVE (–) terminal

RED

BLACK

Step 2

IMPORTANT: Connect the BLACK battery wire to the NEGATIVE

(–) battery terminal. Connect the RED battery wire to the

POSITIVE(+)terminal.Reverse connection of wires will

damage the control board.

Step 3

Plug the transformer into the electrical outlet. (Use of a surge

protector with the transformer is strongly recommended.)

IMPORTANT: This is a class II indoor transformer; if using

transformer outdoors be sure to enclose it in a weatherproof

case.

Program Control Board

Set the Closed Position Limit (for Pull-To-Open Applications)

NOTE: For heavier gates you may need to increase the stall force (see pg 16). If the gate still does not open

or close to the limits you have set, check to ensure that the gate installation was performed correctly

according to the guidelines set forth on page 6. If the transmitter does not activate the gate operator you

may have to reset the transmitter code (see pg 17). If you have a Push-To-Open Installation, see page 22.

Step 1:

TURN CONTROL BOX ON. Your 4000XL has two Limit Settings:

OPEN Limit setting: (Gate in the OPEN POSITION/arm fully retracted). The OPEN limit can only be

adjusted by moving the gate bracket.

CLOSED Limit setting: (Gate in the CLOSED POSITION) To achieve optimum closed position, you are

required to complete the following:

Step 2

Conrm that the power switch is in the ON position and the gate is in the OPEN POSITION (arm fully

retracted).

Step 3

Activate your operator by pressing the transmitter button. Your gate should now be moving from the

fully open position toward the closed position. Prepare to STOP the gate by pressing the entry transmitter

button again when the gate reaches the desired closed position. This step may be repeated until desired

closed position is achieved.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 39 40

Sem comentários

Pro-Built Tools PB1200 Series Manual de Instalação Página 25